2GIG-GB1-345: Go!Control Installation

2GIG-GB1-345: Go!Control Installation


first see the 2gig glassbreak installation manual for
recommended mounting locations hold the 2gig glass-break unit upside down and twist
the base counterclockwise to separate the base from the detector once opened
install the provided batteries into the glass-break unit once you have
determined where to mount the glass break detector drill three pilot holes
using the mounting plate as a guide secure the mounting plate with the side
with the post near the center facing away from the mounting surface use the
provided screws to install the mounting plate to mount the glass break unit into
the mounting plate find the raised alignment notch on the outside of the
mounting plate and the alignment mark on the glass break unit align the two marks
together and then twist the glass-break clockwise to lock it into place make
sure the rely panel is in programming mode and then press the test button on
the top of the unit for up to six seconds the relay pimp make sure to
subscribe to our YouTube page and click the show more tab underneath the video
where you can view valuable links pertaining to this product similar
how-to videos and our low-cost no contract alarm monitoring services

Related Posts

Rhino Rack Road-Warrior Roof Bike Racks Review – 2016 Ford Escape – etrailer.com

TravelSmith RFID Wallet with AntiTheft PacSafe Features

CONFIRMATION. CONFIRMATION. OH CONFIRMATION. OH YES! CONFIRMATION. OH YES! I CONFIRMATION. OH YES! I JUST CONFIRMATION. OH YES! I JUST
How to keep your mobile safe with Sophos

Leave a Reply

Your email address will not be published. Required fields are marked *