Repair of Dent and Tear in Honda Accord Bumper Cover

Repair of Dent and Tear in Honda Accord Bumper Cover


In this video we’re going to show a dent removal and
a weld on a tear in a Honda Accord rear bumper. The first step is to heat the area with a heat gun. This process actually takes about 10 minutes
to make sure the plastic is heated all the way through. Once it’s heated, you push the dent out as much as you can and try to work out the high spots and the low spots. Rough it out first. After you’ve got the dent roughed out,
then you want to weld the tears with the nitrogen plastic welder
and the polypropylene welding rod. “T” the edge for strength on the backside,
then on the front side, we’ll v-groove and we will weld with the – again – the nitrogen
plastic welder and the polypropylene welding rod. After the weld is done, take some 80 grit sandpaper and a DA, and you want to sand the dented area. This will reveal the high spots and the low spots. Heat again if necessary, and again, work it. Push down the high spots and push up the low spots. Sand again. And, again, you’ll see some of the low spots. This time we can push it out without heating, and you want to keep working it until
you get it completely smoothed out. Then we’re going to rough out the weld
with a roloc, some 80 grit sandpaper, a torch to burn the TPO fuzz down. We want to send with 180 grit, and then we’ll finish by using adhesion promoter
and a flexible waterborne primer surfacer. And we are done!

Related Posts

Wired Alarm Panels ( Burglar & Intruder Alarm)

Hi Friends My name is Mahesh Kumar Singh I want to tell about what my new product is What is
The Walking Zomboid | A Project Zomboid Narrative Story
HOW TO: Pair iPhone Bluetooth to Subaru (All 2013 models)

HOW TO: Pair iPhone Bluetooth to Subaru (All 2013 models)

Hi, I'm Tannis Bachman. I'm here today at Bachman Subaru in Louisville, Kentucky, with James. He's going to show you
Traditional Syrian Ice Cream in the USA

3 Replies to “Repair of Dent and Tear in Honda Accord Bumper Cover”

  1. Is it possible to fix a bmw 335is rear bumper that has been hit w a tow hook, it has clean cut right in the middle but is slightly dented in. New bumper is 900 dollars

  2. Visit this video page on our website to see the full list of products used and other helpful tips: https://www.polyvance.com/video/nitrogen-hot-air-welding/repair-of-dent-and-tear-in-honda-accord-bumper-cover

Leave a Reply

Your email address will not be published. Required fields are marked *